The unit must be protected from the following influences: Splashing liquids Direct sunlight Strong temperature fluctuations Direct airflow from heating or air conditioning units. Align the originals in the right rear corner of the document feeder. Place the copy paper on the single feed tray. Explosionsgefahr bei unsachgemäßem Austausch der Batterie. Changing the default settings You can change the default settings of the copier. The maximum radiation capacity of the laser diode is: Di251 5 mW Di351 15 mW. Add copy paper to the empty paper tray.
When you are working in interrupt mode, not all functions are available. For more information, see page 1-2. Did you load a custom paper size? For more information, see page 1-2. The default setting is the 1st mode. An overview of the current copier settings is displayed. If copies are still too light immediately after replacing the toner bottle, you can activate the toner replenisher function. For more information, see page 7-44.
Slide the finisher carefully back to the copier. Access numbers cannot be assigned twice. Pull out the jammed paper found there. In this case, a warning message prompting the user to select the paper size manually will appear. Close the right door R1. Set the position of the file margin on the originals. Load the originals: Load the originals face-up into the automatic document feeder.
Slide the finisher carefully back to the copier. Select the desired Finishing function. For more information, see page 6-28. This can cause incorrect feeding. Ü Unplug the power cord at least once a year.
Which Copy Mode is available? Change any other administrative settings if necessary. An overview of the copier settings for the job program is displayed. For more information, see page 4-25. The copy cycle can be started. Press the paper lifting plate down until it locks. Depending on the model, some of the precautions given in the following do not apply.
Carefully pull out any paper jammed there. Synchronizing Roller is driven properly. Ü Carefully pull the paper drawer out Feed roller as far as it will go. Internal Laser Radiation Mean radiant power at the laser aperture of the print head unit: Di251 19. Ensure that the maximum paper filling height is not exceeded see mark on inside of the paper drawer. Slide the finisher carefully back to the copier.
Carefully pull out any paper jammed there. Carefully pull out any paper jammed there. Boards in a location exposed to direct sunlight and high tem- perature. Lower the document feeder tray again. Different markings are used to denote specific meanings as detailed below. Access codes administrator codes cannot be assigned twice. Shake the new imaging unit a few times back and forth while holding it horizontally.
Press S1 to let the copier start the output sequence. Make any other desired changes to the user management settings. Ü Do not touch areas designated with safety labels. Press the key for the 1st drawer. This can cause incorrect feeding. The time before sleep mode is activated can be changed. Carefully pull out any paper jammed there.