If the light remains on, have the system serviced immediately. Note: The front and rear washer systems are supplied from the same reservoir. Note: Inspect the wheel pilot hole and mounting surface prior to installation. Never use an indoor extension cord outdoors; it could result in an electric shock or become a fire hazard. Please help support this website by shopping at. If not level, adjust the ball height accordingly and repeat Steps 3—6.
Squeeze the two retaining clips on the sides of the fuse box cover towards each other and pull it straight off. And for more free info, the white sticker with the bar code shows your driver's side door code changed to 0's for the pic. Make sure that the under dash cover is securely in place so it won't interfere with the accelerator or brake pedal when you are driving the vehicle. Additives and Chemicals Ford Motor Company recommended additives and chemicals are listed in the owner manual and in the Ford Workshop Manual. Fog lamps Illuminates when the fog lamps are turned on.
Placing your arm over a deploying airbag can result in serious arm fractures or other injuries. After you are done pumping fuel, slowly remove the fuel filler nozzle—allow about five to ten seconds after pumping fuel before removing the fuel filler nozzle. See the Seats chapter for information on head restraints. Run the engine until it reaches normal operating temperature. If fuel is splashed in the eyes, remove contact lenses if worn , flush with water for 15 minutes and seek medical attention.
For example but without limitation, you agree not to rely on the Telenav Software for critical navigation in areas where the well-being or survival of you or others is dependent on the accuracy of navigation, as the maps or functionality of the Telenav Software are not intended to support such. Map Icons Vehicle mark shows the current location of your vehicle. We strongly recommend that you use extreme caution when using any device that may take your focus off the road. Press or lift the switch completely and release. Inflate all the tires to the recommended inflation pressure.
Compression allows you to turn the compression feature on and off. See the technical specifications chart in the Capacities and Specifications chapter. Ford Motor Company and iBiquity Digital Corp. See Capacities and Specifications for more information. Rotate the seat forward to allow access to the third row. The unlock sensor is on the back of the handle.
This control also adjusts the passenger side temperature when dual zone operation is disengaged. The customer warranty may be void for any damage to the engine if such spark plugs are not used. You are responsible for the entire risk arising out of your use of the Telenav Software. Ford Motor Company recommends that the fuel system be inspected by an authorized dealer after any collision. The system is able to analyze different occupant conditions and crash severity before activating the appropriate safety devices to help better protect a range of occupants in a variety of frontal crash situations. To improve air conditioning when starting your vehicle, drive with the windows slightly open for two to three minutes.
Adaptive Cruise Not Displayed when conditions exist such that the Available adaptive cruise cannot function properly. Move the memory features to the desired positions using the associated controls. This overrides any art from your device. If the dissimilar spare tire or wheel is damaged, it should be replaced rather than repaired. To operate the heated seats: Press the button located on the rear of the floor console to cycle through the various heat settings and off. Replace the mini-spare over the jack and secure with the wing nut. When the tire tread wears down to the same height as these wear bars, the tire is worn out and must be replaced.
Push up on the outside rigid edge of the filter and rotate counterclockwise once the tabs are released, then remove the filter. We believe that their specially trained technicians are best qualified to service your vehicle properly and expertly. To attach the new wiper to the wiper arm, align the slot 1 and cross pin 2 and firmly press the wiper arm into the wiper blade until a click is heard. Note: Make sure that you are sitting in the correct position. Note: Make sure that the area under the seat is free of objects before stowing it. Note: If your vehicle is equipped with MyKey®, it is possible to prevent turning the sensing system off. Do not make any unauthorized changes to your vehicle or engine.