For added customer comfort, the air distributed through the floor ducts may be slightly warmer than the air sent to the windshield defroster ducts. A higher energy level is used for the most severe impacts. Park on a level surface, activate hazard flashers and set the parking brake. Add fluid to fill the reservoir if the level is low. The safety belt warning light illuminates 1-2 minutes and the warning chime sounds 4-8 seconds.
To control the auxiliary climate control system from the front controls, turn the fan speed control knob to the desired speed. Remove the two screws and move the lamp assembly away from the liftgate. The use of tire sealants may damage your tires. Enter the factory-set code keypad will illuminate when pressed. These quality products have been specifically engineered to fulfill your automotive needs; they are custom designed to complement the style and appearance of your vehicle. The red indicator light will begin to flash after 20 seconds. Aftermarket products could cause damage to the fuel system.
Rotate the wrench socket out from the handle. Once the disabled vehicle has been started, run both engines for an additional three minutes before disconnecting the jumper cables. Each press will increase the set speed by 1. Storage compartment Press the latch to open the storage compartment. For vehicles with overflow coolant systems with a non-pressurized cap on the coolant recovery system, add coolant to the coolant recovery reservoir when the engine is cool.
Accident statistics suggest that children are safer when properly restrained in the rear seating positions than in the front seating position. An oil change is required whenever indicated by the message center and according to the recommended maintenance schedule. It will automatically move the seat forward to the original position when the key is inserted into the ignition. To increase airflow to the outer panel vents, close the central panel vents. Consult your fuel distributor for the availability of winter grade ethanol. Children must always be properly restrained. Engine oil filler cap 3.
Remove the bulb socket from the lamp assembly. The purpose of the BeltMinder is to remind occasional wearers to wear safety belts all of the time. To install the cap, align the tabs on the cap with the notches on the filler pipe. Clip the tether strap to the anchor. Ensure that the cables are clear of fan blades, belts, moving parts of both engines, or any fuel delivery system parts. Your transmission does not consume fluid.
Wait until the safety belt warning light turns off. Storage compartment Press the latch to open the storage compartment. Pull the webbing through the child seat toward the retractor while pushing down with your knee on the child seat. A correct zone setting will eliminate this error. Press down on the top outboard area of the seatback until a click is heard. If the wiper does not wipe properly, substances on the windshield, rear window or the wiper blades may be the cause. The purpose of these head restraints is to help limit head motion in the event of a rear collision.
Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Do not rock the vehicle if the engine is not at normal operating temperature or damage to the transmission may occur. Everything works like it should. This will also assist in transmission cooling. Take precautions to avoid its dangerous effects.
Displayed when any of the tire pressures are low. Make sure the tongue is securely fastened in the buckle. To install the cap, align the tabs on the cap with the notches on the filler pipe. You are going to enjoy this very car more with the help of the factory manual offered to users on this site. You are strongly urged to buy a reliable tire pressure gauge, as automatic service station gauges may be inaccurate. Power steering fluid reservoir 4. To reduce risk of injury, do not obstruct or place objects in the deployment path of the inflatable Safety Canopy.
Engine oil filler cap 3. Carefully pull old bulb out of the lamp assembly Reverse steps to reinstall bulb s. See your dealer or a certified technician for service of this relay box. Locate the access plug to the brake-shift interlock override. Refer to Filling the tank in the Maintenance and Specifications chapter for more information. Illuminated visor mirror Lift the mirror cover to turn on the visor mirror lamps. To remove a fuse use the fuse puller tool provided on the fuse panel box.